"Mike Pio" wrote in message
news:_g2Ue.19947$sw6.15469@fed1read05...

"Mike Pio" wrote in message
news:Y1aTe.17800$sw6.4183@fed1read05...
I have the Biesemeyer commercial fence system. It's only about a year
old. I guess I never had the right setup tools when I got it, but now that
I do, I notice that the left side of the fence is not 90 deg to the table
and the right side is also off, but closer. I see no way to adjust this
and can't find anything on the web.

Is there some way to make the fence exactly perpendicular to the table
surface?


All,

FYI, I contacted Biesemeyer today about this problem. They confirmed no
way to make this adjustment and offered me a replacement. Because I'm
local to their headquarters here in AZ, I'm going to make the exchange
tomorrow. The rep said they would build one up for me today (making sure
of the accuracy) and have it ready for pickup by tomorrow. I'll let you
know if the new one's build quality is any better...

-m


I got the replacement fence today. It's perfect. I checked the entire
length of the fence (both sides) and it's _exactly_ 90 deg to the table.
They did a very nice job and their customer service was excellent. They
took my old fence in exchange and it didn't cost me a dime -- other than the
drive to the facility.

If any of yours is in need of help, perhaps you could benefit from a call to
Bies?

-m