On Fri, 02 Sep 2005 15:53:45 -0700, charlie b wrote:

I've got an 1100 lb. 3 - 3 hp TEFC motored, sliding
table, combination machine (Robland X31) so the
saw/shaper table and the jointer table are side by
side and coplana Because of the sliding table, a large
cross cut auxilliary table is not necessary. When
the 48" cross cut fence isn't being used it's taken
of the machine and stored in a corner.

So this isn't your first excursion into the madness of wood?


Have you considered spending a $1000.00 to attend a
turning conference?

Let's see, that's about one quarter of a trip to
the emergency room - sounds like a real deal.
But I'd rather spend that sized chunk of change
on some nice wood (I've already got just about
every tailed tool they make and half the hand
tools Roy Underhill has.

There ya go, Roy. There's the guy who got your tools!