hole alignment tool
Sometimes I think I have way too many tools and other times I find that
I don't.
The latest situation was not having a cylinder ridge reamer that was
small enough for a 3.5 hp engine. Okay either make or buy one, or use
a boring tool on the Drill/Mill.
Just enough room to do it on the Drill/Mill. Now just have to get
aligned with the cylinder. Okay I have one of those dial test
indicator holders that clamp on to the spindle. A tool made for
exactly this job. However it has friction joints and I kept touching
it and throwing it off. It was at the end of a longish day and I got
frustrated.
So finally I got a little inspiration and made a test indicator holder
that fits in the boring head. Very simple. Just 1/2 inch rod that
fits in the boring head about two inches long. Milled a flat on it
that made it easy to drill a 1/4 inch cross hole to hold the post on
the back of the test indicator. The flat was big enough that the head
of the indicator snugged in it. Then drilled a hole lengthwise and put
in a set screw to grasp the post on the dial indicator.
Simple, easy to make, and works well.
l .5 l
xxxxxxxxx
x x
x x
x x
x x
x x
x x
x x
x-----x
x x Hole for test indicator post
x-----x
x l l x
xxxxxxx
^
l
Set screw hole
Dan
|