No those are different parts - I could cobble those up readily if I needed
them - in fact you don't need them if your fingers are reasonably agile.

David
"N Cook" wrote in message
...

"David C. Partridge" wrote in message
...
The calibration instructions call for two "calibration units" Tektronix
part
numbers 067-672-00(vertical) and 067-673-00(horizontal), which for sure
are
highly unlikely to be available anywhere 30 years after the fact.

From the instructions, it is my GUESS that the horizontal unit routes
the
input from its front panel to direct to the main X amp input, and MAY
also
generate an unblanking signal (based maybe on its input).

Similarly my guess for the vertical cal unit suggests that when the
"BAL"
function is selected then the inputs to the Y amp are referenced to
ground
via a resistor network or possibly just connected together (possibly via
a
lowish value resistor) and when "CAL" is selected the front panel input
is
fed directly to the Y amp input (pins 5 and 13 on the output pcb
connector).

That's all on the assumption that these units are pretty much passive -
all
bets are off if they are active things.

Does anyone actually know what they do? Or even have these plug-ins or
the
schematics for them?
--
Dave Partridge (remove xwy from replyto email address)



Are they aren't just board extenders for working outside of chassis ?

--
Diverse Devices, Southampton, England
electronic hints and repair briefs , schematics/manuals list on
http://home.graffiti.net/diverse:graffiti.net/