Thread
:
Stamped welding rod?
View Single Post
#
7
Martin H. Eastburn
Posts: n/a
wrote:
Doesn't have to be welding rod. Thats just what we had used
Boss said it was too high from MSC and we are going to look at getting
it by the coil if I can find relativly small quantities. I'm thinking
20 lbs and straigten it myself
Ken
That is what I got. It uncoils but is slightly curved. I don't think it will
matter much once in the tool/work - as the slight cure on the short section
would act to keep it from dropping out. (If it had much flex at all.)
I think it was a 5 pound roll I got.
It is wire not rod. Rod is machined or maintained straight. Wire always bends
just drop one on the floor... :-)
Martin
--
Martin Eastburn
@ home at Lions' Lair with our computer lionslair at consolidated dot net
NRA LOH, NRA Life
NRA Second Amendment Task Force Charter Founder
----== Posted via Newsfeeds.Com - Unlimited-Uncensored-Secure Usenet News==----
http://www.newsfeeds.com
The #1 Newsgroup Service in the World! 120,000+ Newsgroups
----= East and West-Coast Server Farms - Total Privacy via Encryption =----
Reply With Quote