Check the following thread about a week ago. I hope others have some
suggestions to help you...

http://groups.google.com/group/sci.e...2752b98c3d8771


"Ben Galvin" wrote in message
...
Hi,

I'm trying to repair my crashed 200Gb Western Digital hard disk
(WD2000JB). A few days ago it started making a strange buzzing noise, then
about 10 minutes later died completely. Naturally, I had forgotten to
backup the contents of the drive (lesson learned). I tried a few hard
drive recovery services but they were all quoting about $2500 for recovery
of a hard disk with a mechanical fault - a bit steep for me.

Ok, so I figured I may as well have a go myself - nothing to lose. I setup
up a 'clean room' in my bathroom (cleaned it out, used an ion generator
and the hot steam from the shower to temporarily settle the dust down). I
know its nothing compared to a professional one, but it's the best I can
do. I opened the hard drive for about 30 seconds, enough to determine that
the platters couldn't be moved around by hand. I opened another similar
hard drive (with no data on it) and was able to move the platters easily,
so I'm assuming there must be something wrong with the bearings in the
hard disk. I've managed to get hold of another (almost) identical
motor/bearing assembly, and I'm going to have a go at swapping them over.

My problem is that my hard drive has 2 platters inside it (basically like
2 CDs stacked on top of each other with a 1cm gap between them), but I
don't know if I need to ensure that they stay perfectly aligned when I
moved them to the new spindle or not (imagine rotating the top cd around a
vertical axis by 10 degrees - the data would no longer be sychronised
between the 2 platters). There are no marks or holes to tell the
orientation of the platters, so it would be very hard to take them both
off one spindle, and put them on to the new one and preserve this
relationship exactly.

Does anyone know if I need to do this, or have any other advise?

Thanks,

Ben