In article , Dan says...

Total newbie here. I have got a 1/4" carbide end mill (1 1/4" cutter - 4"
O.A.L.) that is to long. I would like to cut about 1/2" off of the shank
and then use it . Is this ok to do? I could mill it off or cut it with an
abrasive wheel. Thanks all

Solid carbide? You're going to need a diamond wheel to do that.

Jim


--
==================================================
please reply to:
JRR(zero) at pkmfgvm4 (dot) vnet (dot) ibm (dot) com
==================================================