Thread
:
Derive low voltages signal/output from PIR floodlight?
View Single Post
#
8
[email protected]
Posts: n/a
Ian Stirling wrote:
wrote:
I would like to derive an audio alert from a PIR floodlight. To be more
specific: let's say I have the floodlight above a back window and
driven from a three-pin plug from inside. I would be happy to bring
additional cabling from the PIR.
The safest and simplest way to do this is to find a 240V relay that will fit
inside your PIR device. (assuming you are competant to fit this safely,
properly insulated, and secured)
As most floodlights have a choccy block connector in, simply connect the
relay coil across the floodlight terminals.
Now, you have a switch that goes on when the floodlight does.
Connect this to a source of power, and the bell/buzzer of your choice.
What terminals are on that 240-V relay? 240-V (live and neutral) in;
two terminals of the switch out? There's not much room left in the
plastic box that contains the choccy block connector -- is that where
you'd put the relay?
Many thanks,
Jon C.
Reply With Quote