Depending on the receiver type, there may be a computer type battery on the
circuit board for the receiver's uPC. In some models, they use a gold leaf
capacitor that is in the range of about 0.5 Farads or so. This is to store
the active memory for the receiver. If the battery or the cap is defective
and the temporary memory is lost, then the uPC must re-initialize and
restore the system's temporary memory before it can function again.

If the battery, or the cap (depending on the receiver) is in good condition,
then your fault is most likely a component that has become temperature
sensitive. After the set has warmed up, the associated function starts to
operate again.

--

JANA
_____


"Michael Rabeno" wrote in message
...
Hi all,

I have a weird situation on my Kenwood A/V receiver. It seems that when my
receiver is turned off for a while, the remote can't operate it (it's in
stand-by mode), but if I manually turn on the receiver, then after a while
(10-15 min.) the receiver seems to respond to the remote.

I've already checked that the remote is outputing infra signal from it's
led, and it does. I've even tried a universal remote control with no help.

Ideas anyone?