The toilet in our downstairs bathroom was wobbling a bit. I figured
that maybe the bolts were loose and tried tightening them, but it still
wobbeled. I figured that with the movement the bolts may have slipped
out of there slot. Went and got a new wax ring and bolts to repair it.
Took the nuts all the way off, lifted up the toilet and found that the
flange remained with the toilet and seemed to have broken off from the
pipe. Withour going into detail, it was going to get fixed viw our
home owners warranty. The tech has soldered on a replacement ring
(brass) and left telling my wife that he needed some screws that he did
not have with him, and that he would be back the next day to finish the
job. In the interim, I guess he changed his mind and let the warranty
company know that he would have to break the concrete to replace it,
that is not a "covered" item.

I now have a soldered on flange. I would say the solder is about 75%
all the way around. It is attached very solidly. I have no idea what
made the guy change his mind, or what screws he needed initially to
finish it. I am almost tempted to use it as is. The replacement flange
ring is above the concrete floor with 4 screw holes. I am thinking of
screwing it to the floor with some spacers for addition stability. I'm
not sure the those would be the screws he was refering to or not.

Any ideas? The worst thing that could happen would be for it to break
again, than I would replace the whole flange. This ring seems solidly
attached with the solder. What screws might he have been refering to?
Anyone familiar with this type of repair?