"rbel" wrote in message
...
In message , Brian Sharrock
writes

"Set Square" wrote in message
...
In an earlier contribution to this discussion,
rbel wrote:

All the cold water piping from the tank to outlets in our 1970s
property is 17mm OD grey plastic piping. Grateful for any
suggestions on how to adapt this to copper. I would strip everything
out and start again but the existing is neatly buried in walls or the
concrete floor.

That's an unusual size! What sort of fittings are currently used? Can
you
upload a photo of a bit of pipe with a fitting somewhere on-line, and
post
a
link to it here?

It wasn't an unusual size at the time (seventies) ...
indeed my BCO more or less insisted that such pipes
were used for cold services. {when the existing lead pipery
was being removed and replaced. IIRC, the pipes were
made by 'IMI ~ Yorkshire" under the trade name 'Poly-York"
-[I may have this wrong]. The pipe was meant to be solvent-welded
with in-line joints made with a female-female union.
I had grey pipes (large) and black (small) diameters equivalent
to 22mm and 15mm copper. {Once again this may have been a vagary
of supply]. Unions, elbows, tap and tank connectors were all
available. Connection onto the cold-water main was via a
tap-connector. When I needed to modify the design , I could
no longer source the bits. I discovered that a push-fit connector
actually went over the 17mm OD ... after which it's an exercise
in connecting to the resultant copper pipe.

Apparently, as the hot water (adjacent) pipes had to be copper
the plumbing trade didn't find using a parallel plastic circuit
either cost nor time saving and the product went off the market.

I hope to banish the final circuits of it from my house over
the next twelvemonth ... when I get a round tuit.

It is exactly as you describe. You mention using push-fit connectors -
any specific manufacturer or will any do?
--
robert

FWIW ... CAVEAT ... NO RESPONSIBILITY ASSUMED NOR IMPLIED
Observation indicates that I used 'Pushfit' which just
happened to be what B&Q stocked - this is after I'd
tried going from 'Plumber Supply Merchants(various)
and had spotty yoof-experience people regarding me as
'mental' for even enquiring about the product. HTH.

I had a 'complete' cold water system - rising main to storage
tank then tank connectors to bath/shower/toilets on separate
feeds. The rising main has been converted to copper; as has the
bathroom feeds - now just the toilet feed needs to be replaced.
The round tuit I'm anticipating will include a heat-store which
will eliminate the cold-water storage tank and the final few
metre lengths of Poly-YorK(?). BTW, the plastic is (IIRC) ABS.

--

Brian