On Wed, 27 Jul 2005 12:15:21 GMT, "Carl"
wrote:
I've built these for a marine tank of larger size as well as the sort
of size you describe..
Great! Someone who had already done this!
Its been on on these projects "in the pipeline" for a while
Marine ply is very expensive because it is free of voids as well as
being water resistant. For this application, WBP (water and boil
proof) is adequate, readily available and a lot less expensive.
Not worked with ply much before, and appreciate the tip! Trust this is
avaliable from my regular timber merchant.
It should be. 18mm is very readily available but the other sizes
should be as well even from DIY stores.
For this size, I would say that 5mm would be just about OK as long as
you are not going to house the ballasts for the lighting in it. If
you are, then I would go up to 9mm.
Intention was to run the lighting as an Arcadia T-bar
(http://www.aquatics-online.co.uk/big...adia_I_bar.htm) with the
lighting fitted on "runners" on the tank from so that it can move forward
and backward to gain access to the tank, without having to remove the
lighting unit. In this setup there is no additional weight on the lid.
OK. Don't forget to fit an RCD on the supply to the lighting.
I have one for the lighting and a separate ones each for the heaters
and pumps. The main risks you have are the lighting assembly falling
into the water, then with heating and pumps some sort of leakage or
breakage.
The idea is that if one thing goes, it doesn't remove the supply to
everything.
The most critical aquarium issue is oxygen, but as long as you don't
overstock the tank then loss of power is not a short term problem -
there is enough absorption at the surface.
I avoid using anything metal near a marine aquarium, but if it's fresh
water then less critical. Even so, I wouldn't use aluminium. For
this application, I would construct using entirely wood including a
wooden frame. Glue together with an exterior grade of woodworking
glue or even epoxy.
Use plastic hinges for the lid or avoid hinges altogether by having
the top drop into place on the frame. It's just as effective.
Great Tip? Plastic hinges may be hard to source, but two panels work work
ok, and as you suggest be easier.
Especially as you aren't fixing anything to the lid. To be honest, in
that size, making it as one piece would also be OK.
For finishing, I use glass fibre cloth and epoxy on the inside. You
can get this from model aircraft suppliers. It doesn't need to be
heavy grade as the main purpose is to protect against water.
With fresh water, you could use several coats of a solvent based yacht
varnish and get almost as good an effect. Either way, it needs to
cover the inside and the surface in contact with the tank itself.
It is a freshwater tank, so I will consider both options.
Don't forget to allow some ventilation. Conventionally this is slots
or holes at the back. Otherwise, you run the risk that the heat from
the lighting will raise the water temperature too much.
For the outside, it's less critical and almost anything will do
although should be splashproof at least in case you drip any water on
it.
Final color will be black, so I am sure something can be found to acheive
this.
--
..andy
To email, substitute .nospam with .gl