"Mark Healey" wrote in message
news
I'd like to cut some rings to make chainmail. I'm using 16ga mig wire and
winding them on a 1/4 inch dowel.

I want to cut them with a jewelers slotting saw. I've found the blades
all over the place but can't find an arbor that will fit into a 3/8 inch
drill chuck. Where do I get one?

--
Mark Healey
marknews(at)healeyonline(dot)com


Hand holding a jewler's saw in a drill might prove a little vicious... It
is going to want to grab and jerk. I'd suggest a Dremel tool with a cutoff
wheel.

Jerry