Thread
:
Garage Pad and concrete block
View Single Post
#
7
Big_Jake
Posts: n/a
I built my garage over the winter, and did 9' walls with 104 5/8"
precut studs. No cutting required.
We tend to run conduit up to outside wall of the garage through an "LB"
into the building. This will vary from area to area. I am in
Wisconsin.
JK
wrote:
I'm building a 24 x 28 garage/shop and would like to have more than an
8 foot ceiling height in it. It's going to be a 4" monolithic pad and
I was thinking of laying 1 or 2 courses of 8" concrete block and
building with standard studs to keep from doing lots of cutting. One
corner of the pad will be about 16" - 20" below grade, but I won't be
backfilling around it, so I think I will be ok.
Some questions...
1. Any issues with this approach for increased height? Will put j
bolts in block and pressure treated sil plate.
2. When running the electrical conduit (stand alone garage), would you
run the underground conduit through the floor/block so it goes straight
up the inside walls?
3. If I am using 1 or 2 courses of block, is there a recommended way
of tilting up the stick framed walls onto the block/sill plate?
4. any general suggestion/things to look out for?
Reply With Quote