In article ,
David Lang wrote:
Is there a way to test 14.4v batteries from a drill driver to see what
condition they are in?
I only have a volt/ohm meter.
You'll get a rough idea by discharging them into a known load - something
like a car 21 watt stop light bulb would be ideal.
If they are Ni-Cads, they're likely to have a capacity of about 1.5
amp/hr, so I'd expect them to run the light at full brightness for about
45 minutes. However, one or more cells always fail first, so if there's a
problem, I'd expect it to be very much less.
High quality cells in good condition should do longer than 45 minutes.
--
*Everybody lies, but it doesn't matter since nobody listens.
Dave Plowman
London SW
To e-mail, change noise into sound.