Where would I obtain such a module PC board, the number is PB8185?. Is the
outputs located on this board? or is it the other smaller board that
connects to the convergence coils on the neck of the tubes? also what about
the STK chip that powers the convergence,would it be a good idea to replace
this also?. Due to the strain on the chip from the convergence board going
all whacky?

Thanks,
James

wrote in message
oups.com...
Very good chance you will be replacing the digital convergence module
to fix it.
Try replacing the bad convergence output first, but usually it either
works or it doesn't.