Hello, Mike!
You wrote on 11 Jul 2005 04:40:13 -0700:

M It's a Hitachi CPT 2224

M There's a small circuit board attached to the very centre of the back
M of the screen, there's two solder joints that look as if there's a hole
M going through them. They're marked GND and K1.

Don't think that's it Mike, your looking at the CRT pins. The vertical
oscillator section will be on the mainboard. I don't really recommend you
try to fix this yourself, as you really need access to the solder side of
the main chassis, and there are potential (no pun intended) problems
concerning dismantling reassembly and safety that call for a bit of
experience. Take it to a repair shop, at this point the repair is likely to
be an easy one, but an inexperienced repairer could soon fix that. :^)
Best of luck.



With best regards, 3T39. E-mail: