"_ZZ" wrote:
I'm trying to deal with small Torx screws on a drive case. They're
about T8, maybe T7. Tough to tell cause the screws are
'pre-stripped.' In other words, there's not much edge for a Torx
driver to grip them. They almost look like rounded allen-head screws.
I'm trying to figure out how to deal with them.

These are not the tamper-proof variety, so I don't need a hollow-point
Torx driver (if they even make them that small).

The first thing that occurred to me was to place a small Torx driver
in the holes and tap the end lightly with a mallet. That could do
more harm than good though, as this looks like very soft metal. It's
also a working disk drive case, so I don't want to damage the drive.

I could try a tiny screw extractor, but the risk is that it wouldn't
work and then the remainder of the screw would really jam things up.

Clamp a small pair of vise grips on the outside of the fastner to get the
screw started, then continue with whatever method (vise grips, fingers,
torx, et cetera) you prefer from then on out. If that doesn't work, slit
the screw and use a flat screwdriver.

Jon