I apreciate your help!

I will follow your advise.

Montenegro


wrote in message
oups.com...
Two things, you want to find the stud and you want to avoid wires and
pipes. Wires are *usually* run inside walls so as to be equidistant
from the wall surfaces.

IMO the easiest way to do what I think you're trying to do, which is
hang a small table sruface, is to lightly mark off where the surface of
the table will be on the wall. This could result in a rectangle, say,
4 feet by one inch. Within there, since the table will cover up the
probing, poke thru with a hammer and nail some holes, just enough to
figure out where the studs are and to see if any wires are obvious.

The a*** retentive way is to rent or borrow or by one of those tester
thingys that finds wires inside walls, that electricians use.