W. Watson wrote:
Edwin Pawlowski wrote:

"W. Watson" wrote in message
ink.net...

Anyone know the frame # for the model above? If not, I'll call Delta
in the morning.




Look at the motor. Is it a base mount or c face? If it is a 1/2"
shaft, it is a 48 frame. If it is 5/8" shaft, it is a 56 frame.

You may find a replacement at McMaster or Grainger.

Hard to get to at the moment, but I would think it's a base mount. Axle
is difficult to measure, but it appears to be much closer to 3/4", so
it's likely 5/8th if those are the two choices.

I have a local dealer.

One morning it just stopped working. I turned it on and the motor just
produced a grumbly hum. I've tried replacing rhe capacitor--no change. I
can rotate the axle by hand without any difficulty. The switch seems OK.
The shaft does not move in and out. Very strange. I've had it 4-5 years
and I'd be surprised if I've put 4 hours on it.
Hi,
Centrifugal switch inside the housing maybe shot. That switch controls
start/run mode of the motor. You have to take the motor apart to check it.
Tony