What is your experience using this machine? (What is the concensus of this
newsgroup?) I've thought about buying one of these as a replacement for my
$50 benchtop drill press -- I dare say it would do better than that little
thing, plus give me some limited milling capability ... but how limited?

Thanks,

Andy

"BillP" wrote in message
news:Ax2xe.9540$4o.3492@fed1read06...
Hi, Guys!

I've managed to get along without a clamping kit for my Big Red
Mill/Drill ( HF 42976) for some time now, but it's time to bite the
bullet.. I've seen comments about this Mill/Drill and am checking Ebay
for kits... A bit confusing, to say the least.
The upper slots in my table are .490" wide, or about 12.49mm and the
lower slot very close to .625"....
3/8" kits are available on Ebay, but mention half inch slots... Will
the kit on ebay (for example, http://tinyurl.com/7b9n2 or
http://tinyurl.com/bp637 do the trick?

TIA
Bill