"Jeff Wisnia" wrote in message
...
John wrote:
I'm trying to determine which of the acids we used to use, in the old
days, to disintegrate broken taps or drills. I remember when that was
done occasionally, but don't remember which acid was used. I have a
friend who has a broken drill in cast iron and I thought this might be a
possibility before we start chopping at it with carbide tools and make
matters worse. It might at least loosen it up enough to remove by hand.
It's a 1/8" dia. drill and not in too deep, about 3/16", but it's bound
pretty tight.

Thanks
John


If you find something which will disolve tool steel out of cast iron
without eating up the cast iron too, please let me know.

Think EDM...

Jeff
--
Jeffry Wisnia

(W1BSV + Brass Rat '57 EE)



You're right Jeff, it might eat up a small amount of the C.I., but in this
particular case that's not to important. The part is too odd shaped to
mount to a machine table to mill out. If we could loosen the drill slightly
I think we might be able to get it out.

I just remember that in the past there have been occasions where we removed
broken cutting tools from a base material with an acid. I don't recall
which specific acid or base material worked the best. Obviously if it eats
up your part it wouldn't be too good. I wouldn't propose doing it on a
precision machined part, that's why I thought this group might have a
suggestion or two. I've removed many broken tools over the years with left
hand drills and left hand carbide end mills, but that won't work too well in
this case.

73,
John (W7JDA)



----== Posted via Newsfeeds.Com - Unlimited-Uncensored-Secure Usenet News==----
http://www.newsfeeds.com The #1 Newsgroup Service in the World! 120,000+ Newsgroups
----= East and West-Coast Server Farms - Total Privacy via Encryption =----