"Leon" wrote in message
. ..
Basically all I was trying to point out is that the little area recognized
and descried as "snipe" on the board, can be often caused by improper
feed
as well as the out feed table not being set up properly. Whether it is
actually snipe or taper would be hard to tell. The definition of snipe
sorta goes along the same lines as the definition of a biscuit cutter.

I think the difficulty would apply only to you, Leon. Most of the rest
recognize snip as the image of the cutters formed as the board drops after
TDC onto the low table. It is consistent in form and extent, a condition
almost impossible to achieve with human error.