You Welcome Lou. JG
loutent wrote:
In article , JGS
wrote:
A while back someone mentioned that the 23G pins were not properly set
below the surface when he used his PC pinner. While searching for
something else I can across a post where another user with the same
problem used a grinder to remove a bit of the nose and the problem was
resolved. For what it's worth. Cheers, JG
Thanks for this JG. I like the PC pin nailer that
I bought about 6 months ago, but sometimes I
do have the problem of the pin not setting deep
enough (using it on oak mostly).
This seems like a logical solution. I'm going to
keep it in mind and give it a try next time.
Thanks again!
Lou
|