Snipe is caused by outfeed table to LOW...

Dave

Leon wrote:

"Gerald Lasco" wrote in message
...

Hello Everyone, I need some help here. Using my 8" jointer, which I
think is set up right, the very end of the board has a slight snipe in
it. I quess the question is what am I not doing right or what I am I
doing wrong. Thanks for the help. Gerald


It could be that your out feed table is too high in relation ship with the
cutters or it could be your technique.
Be sure to only have you hands on the out feed side of the table when
pushing the trailing end of the board through the cutter.