Thank you George

Its a square motor, and yes the coolong fins are on the shaft side. Also
there are four screws left on the motor where the brackets were attached. I
could probally also secure it to the box with these making sure that i cut
out that side for the air cooling.

Keith

"Keith Young" wrote in message
...
Hi
I,m back again.

I have a used two speed washer motor for my Beale buffing system.Any
suggestions for mounting? I was going to enclose it in a wooden padded box
on top of my workshed counter top. I,m sure that there are better methods
. The mounting brackets with it were designed for washer mounting.

Any help/suggestions would be greatly appreciated.

Keith
Newfoundland