In message . com,
writes
Hi All,

I need to replace the bearing on my WDS1183W Zanussi Washer-dryer.
I've read a few posts about doing it, and I still think I'd like to
give it a shot!

Check the price of a new bearing kit first and then weigh up whether
it's worth it


Lots of people have said that the whole drum needs to be removed. Is
this something that is easy enough if taken systematically, or would it
require special tools/knowledge?

I've done a couple, without any specialist tools. The problem can be
getting the old bearings out

Be prepared to get lots of cuts on your hands and arms, them's sharp
edges in cheap white goods


Then there are the bearings themselves - lots of people are saying that
you need special tools to remove them - although some have said you can
knock them out, if careful.

Correct, in my experience, no special tools req'd

What about putting the new ones back in -
do they need to be forced into place?

Ooooooh - care and TLC - you can drift the new bearings in with the old
bearings, but don't damage the shields or seals


I'm usually pretty good with this type of thing, but a washing machine
is new territory, and I'm still deciding whether or not to give it a
go! Any advice appreciated. If I do go ahead I will probably do a
photo guide of the whole escapade.

Well, it you make a total mess of it you've

a) lost the cost of the bearing kit

b) gained some experience

--
geoff