On Tue, 7 Jun 2005 12:01:24 -0400, George wrote:

"Brian Mahaney" wrote in message
...
However, I would like the blade to be a tracking a little
closer to the center of the wheel. It is close, but not where I would put
it if I had the ability to move it farther back. Also, when I move the
blade by spinning the upper wheel, the blade touches the bearing more
often
than not. It's just too close to be how it's supposed to be. I've
actually considered tapping new holes to mount the assembly. I could
easily mount it closer to the center of the adjustment range. Don't know
why they didn't do that in the first place.

Time to move the wheels forward the thickness of one washer....

Now there's an idea. Elegant. Simple. Reversible. I like it. Might try
it. I'd use machine bushings. They are more likely to be the same
thickness. This sounds easier than drilling and tapping.

Thanks,
Brian