toller wrote:
"no(SPAM)vasys" wrote in message
...
toller wrote:
I bought an unused Rockler router table fence at a garage sale for $6!
That is the small gloat.
I will be using it on a table I am making for my table saw wing. That
will require cutting the 36" fence down to 27". This is the small
problem.
I have some dubious carbide table saw blades I picked up for almost
nothing at other garage sales. If I stick one in my table saw, will it
cut the Rockler aluminum extrusion without damaging me, the extrusion, or
the saw? (I don't care about the blades...) Sure, I can use my sawzall,
but it will look like I used my sawzall.
I made a 27" fence out of my 28" aluminum Incra miter gauge by cutting it
with my good Forrest Woodworker II. A nice clean cut and it didn't hurt
the blade at all.
Great, I was hoping someone else had tried it...
Note that I didn't say that I made the 27" fence on purpose though.
--
Jack Novak
Buffalo, NY - USA
(Remove -SPAM- to send email)