On Wed, 01 Jun 2005 06:27:03 GMT "James Sweet"
wrote:

Might be helpful to poke around on the board with a sharper tool, like a
philips screwdriver with electrical tape on the end to insulate it. Then you
may be able to localize down to a more specific component.

The localized pressure idea is a good one, but I'd stick with a
totally nonconductive tool. There are many possibilities: popsicle
stick, Bic pen turned around, plastic knitting needle, plastic tuner
alignment tool, etc....

-
-----------------------------------------------
Jim Adney
Madison, WI 53711 USA
-----------------------------------------------