DIYbanter - View Single Post

wrote:

Coustanis wrote:

I just replaced an exterior door on my house and noticed a problem.
The old door seemed to fit fine with the interior molding fitting

properly.

I replaced the door and door frame. When I had the old door / frame
removed to reveal the rough opening, I noticed (on the interior side)

that the sheetrock on the left side and the right side are on

different

planes. That is to say that the sheetrock on the right side is about

1

half to 3 quarters inch further into the house than the left side.

This creates a situation where, if the new door / frame is flush to

the

sheetrock on the left, and thus proper fitting molding, it is

recessed

the above measurement into the wall on the right. This causes the
molding (which is attached to the sheetrock ) to have a half inch or

so

gap the entire way down that edge of the door.

Across the top is another matter. Across the top from left to right
causes a wedge shaped gap. Tight on the left and gapped on the

right.

The only way I can think of to fix this ( because I cannot twist or
angle the door) is to fill in the gap with a wood strip ( and a wedge

shaped strip across the top) or to recess the moulding into the
sheetrock. Both of these solutions have asthetic problems.

Has anyone experienced this problem?
How did you fix it?
Did I explain this in a way that you even know what I'm talking

about?

Advice is highly appreciated.

Thank you.

fill it and caulk it. it's not worth the extra trouble. you will never
notice it.

That's pretty much what I was thinking.

Thank you