On Thu, 26 May 2005 02:15:35 GMT, the inscrutable Ken Sterling (Ken
Sterling) spake:

Gang,
If you care to, take a look at a modification I did to a zero-turn
riding mower front end caster setup. The original (I think) was a bad
design and I couldn't think of an easy fix. Picture *have* been
renamed THIS time G and I decreased the size of the files for
faster downloading..... hope I did it all right.
Thanks for looking - and any and all comments appreciated.

Very nicely done. Some cleanup and paint prior to the last picture
would have done you service, though.

Point taken. I installed the casters, then took the picture, then
took the machine down into my "back 40" and beat it pretty good just
to make sure the design would hold up.... then finished the job, but
didn't take another picture. Sorry. Ken.




Find them at:
http://www.metalworking.com/DropBox/caster0.txt
http://www.metalworking.com/DropBox/caster1.jpg
http://www.metalworking.com/DropBox/caster2.jpg
http://www.metalworking.com/DropBox/caster3.jpg
http://www.metalworking.com/DropBox/caster4.jpg
http://www.metalworking.com/DropBox/caster5.jpg
http://www.metalworking.com/DropBox/caster6.jpg
http://www.metalworking.com/DropBox/caster7.jpg
http://www.metalworking.com/DropBox/caster8.jpg


--
REMEMBER: First you pillage, then you burn.
---
http://diversify.com Full Service Website Development