Gang,
If you care to, take a look at a modification I did to a zero-turn
riding mower front end caster setup. The original (I think) was a bad
design and I couldn't think of an easy fix. Picture *have* been
renamed THIS time G and I decreased the size of the files for
faster downloading..... hope I did it all right.
Thanks for looking - and any and all comments appreciated.
Ken.
Find them at:
http://www.metalworking.com/DropBox/caster0.txt
http://www.metalworking.com/DropBox/caster1.jpg
http://www.metalworking.com/DropBox/caster2.jpg
http://www.metalworking.com/DropBox/caster3.jpg
http://www.metalworking.com/DropBox/caster4.jpg
http://www.metalworking.com/DropBox/caster5.jpg
http://www.metalworking.com/DropBox/caster6.jpg
http://www.metalworking.com/DropBox/caster7.jpg
http://www.metalworking.com/DropBox/caster8.jpg