Ok Maybe a break on the board or you have missed a bad component.

kip
"Rono" wrote in message
...
You guys are missing the info!! These units will not run
with high standby B+. Scopes & EEPROM changes won't
fix it. I tried everything I could think of. Just read again. Rono.

RCA 25" M # 25GT536, chassis # CTC177AG. Unit was dead,
replaced STK-730-010 (shorted), R104 1.5 meg ohm (gone high),
C4105 10UF @ 250 Volt (gone leaky), checked/replaced CR4108
(130 volt line), changed C4402 (warped), 12 volts, & 5 volts standby
is fine, 5 volts to EEPROM, & tact switches, but 130 volt line is +146
volts dc. B+ to LA7610 main jungle IC +7 volts. B+ to horizontal output,
& drive is + 146 volts, & unit won't start. What did I miss? Rono.