Franz Fripplfrappl wrote:
I have acquired a table that is teak veneer over particle board.
It's an OK table but there are gouges in the veneer which expose the
particle board. Worse gouge may be 3/8-1/2" long x 1/8-1/4" wide.

Any suggestions on how to fill the gouges and to blend with
surrounding veneer?

Buy some teak veneer and make dutchmen.
__________

Also, it looks as though someone overtightened a screw to the point
where it shoved some of the veneer up. Can this be moistened and
then ironed to bring back to match surrounding surface?

Maybe. Depend on what glue was used and if the screw pushed up (and
broke off?) bits of particle board that are still there.

--
dadiOH
____________________________

dadiOH's dandies v3.06...
....a help file of info about MP3s, recording from
LP/cassette and tips & tricks on this and that.
Get it at http://mysite.verizon.net/xico