Sam Goldwasser wrote:
"cnctut" writes:

spongehead--

A carb swap may solve your problem if off a similair 3.5
engine--too
much work though. You mentioned your throttle adjustment was
frozen--you might try advancing the control wire (pliers might
help)
toward a faster run postion to get away from slow idle.

If this doesn't work--carb cleaner would be my next attempt at
solving
the problem. Squirt it every where (in and around the carb.)

Lastly, as your time and parts cost creep higher and higher--don't
forget a new 3.5HP mower is only $99. ;-))

What fun is that? ;-)

--- sam | Sci.Electronics.Repair FAQ Mirror:
http://repairfaq.ece.drexel.edu/
Repair | Main Table of Contents:
http://repairfaq.ece.drexel.edu/REPAIR/
+Lasers | Sam's Laser FAQ:
http://repairfaq.ece.drexel.edu/sam/lasersam.htm
| Mirror Sites:
http://repairfaq.ece.drexel.edu/REPAIR/F_mirror.html

Note: These links are hopefully temporary until we can sort out the
excessive
traffic on Repairfaq.org.

Important: Anything sent to the email address in the message header
above is
ignored unless my full name is included in the subject line. Or, you
can
contact me via the Feedback Form in the FAQs.

Sam

There are practical limits to fun--the grass keeps growing and the wife
doesn't like it long. Remember that microwave I was trying to
fix--"Sharp powers down after 40 seconds"--couldn't get parts so bought
a new one. The wife is very happy now--should have bought a new one
earlier--good note is that my parts box is now full of used microwave
items--maybe I can use some of them before I die--probably not
though.;-))

Tut