Yes But its just easier to put a New one in
cause the chances of him ruining the valve is pretty good.
We are not talking big coin here ..
Just done my Lawnboy ..
cheers
kip
"Sam Goldwasser" wrote in message
...
"kip" writes:

Change the needle valve..
Get a Carb KIT.

Unless he tightened the needle valve with a pair of Vice-Grips, needle
valves don't go bad, but may get dirty.

Clean the carb first.

--- sam | Sci.Electronics.Repair FAQ Mirror:
http://repairfaq.ece.drexel.edu/
Repair | Main Table of Contents: http://repairfaq.ece.drexel.edu/REPAIR/
+Lasers | Sam's Laser FAQ:
http://repairfaq.ece.drexel.edu/sam/lasersam.htm
| Mirror Sites:
http://repairfaq.ece.drexel.edu/REPAIR/F_mirror.html

Note: These links are hopefully temporary until we can sort out the
excessive
traffic on Repairfaq.org.

Important: Anything sent to the email address in the message header above
is
ignored unless my full name is included in the subject line. Or, you can
contact me via the Feedback Form in the FAQs.