In article , Rick R says...
If you have to wipe the joint you used too much solder. It should have a
small fillet.
The rule I've heard is you need about 1/2 inch of plumbers (1/8 dia)
solder to do one joint on 1/2 inch copper, 3/4 for 3/4 inch, and
so on.
I always wind up using a bit more though, and have to flip off the
extra drop at the bottom with the solder.
Jim
--
==================================================
please reply to:
JRR(zero) at pkmfgvm4 (dot) vnet (dot) ibm (dot) com
==================================================
|