On Tue, 3 May 2005 11:46:17 -0700, "Harold and Susan Vordos"
wrote:


"Ignoramus18741" wrote in message
...
I would like to know if I can buy some gizmo that can provide a
definite, positive stop to the lathe carriage before the cutter or the
carriage hits the chuck. Any suggestions, at least what are these
things called.

i

Be *very* cautious in your application of carriage stops, especially if you
machine doesn't have a reactionary clutch for the longitudinal feed. One
mistake can cost you the feed train. It's especially bad if you're using a
lead screw with half nuts, such as when threading. The slightest mistake
in judgment will destroy your machine.

Harold


You will find out if you have a shear pin, or a shear gear, sooner or
later.

Gunner

Liberals - Cosmopolitan critics, men who are the friends
of every country save their own. Benjamin Disraeli