I have a Smith mill/lathe that I have a 1/2 hp D.C. motor and controler and
it works real well. I got the motor and controler from a place in Cestline,
Ohio http://stores.ebay.com/id=11818209&s...TRK:MEFS:MESST
http://cgi.ebay.com/ws/eBayISAPI.dll...2179 049&rd=1

They don't have a motor listed on ebay, but they do have a controler list
for $25.00. I was at there location Saturday and I think they had a couple
1/2 hp motors. They are a recycler so stock comes and goes. I think there
phone number is 419-683-3535. I have gotten a lot of stuff from them, both
from ebay and at there location.

JIm Geib
Mansfield, Ohio

"stag" wrote in message
oups.com...
Wondering if anyone has any suggestions for putting a variable speed
motor controller on my little 110V mill/drill. The belts are a *******
to adjust for different speeds... it would sure be nice to just turn a
dial and still get reasonably good torque w/ a reasonable amount of
speed variablility. And, I'm doing a CNC conversion soon, so this would
really be a + (especially if it has an an analog input for adjusting
speed).

I've seen a lot of Variable Frequency Drivess on ebay for 3ph stuff...
wish I had a big mill with that kind of motor... but my mill/drill will
have to do for now.

What about 110V 1ph? What kind of motor controller and who are good
sources? Is this even a good idea?