T i m wrote:
Hi all,
My daughter and I made some basic 'Pan Pipes' tonight from various
lengths of white PVC 15mm water pipe.
To tune each pipe as we made it we wraped some masking tape round a
jointing dowell till it was an interference fit inside the end of the
pipe then tuned the note to her tennor recorder.
So far we have 7 'pipes' ;-)
For a better adjustable 'bung' I thought a short length of rubber
'bar' would be good. It could be lubricated for tuneing then trimmed
flush with the end and finally locked in with some superglue etc.
I tried a local Car Spares place thinking I might find a very thick
'O' ring or similar that I could cut up into 1" lengths but no luck? A
Hoover 'upright' drive belt might also do the trick but I think it's a
bit too small in section?
So, anyone know an 'everyday' supplier of a rubber 'bar' that would
fit snugly inside some 15mm Speedfit (is it) type PVC pipe (so 11-12mm
OD rubber might do it?).
Yup.
try
www.vintagecarparts.co.k.
10 quid minimum order tho, so its a lot of pipes ye'll be makin begorrah!
All the best ..
T i m