I have turned for years with just glue blocks and face plates. I have
achieved good results but have reached the point where I'm thinking I will
succumb to the pressure and get a chuck. I turn primarily hollow forms both
in dry and wet woods. In the wet woods I'm looking for something to hold the
roughed out piece so that I can hog out the core to speed up the drying
process. The piece is then left to dry for a period of time with the
outside waxed. Once dry then I will remount it and finish it off. I have
always used the glue block method and have 15 to 20 pieces on the go at any
one time. I'm thinking a new chuck may assist. Any suggestions on your
favourites?

Vince