"Upscale" wrote in message
...
"BillyBob" wrote in message

I have the sliding table on a jet supersaw. Would I buy it again?
Well,
I'll probably upgrade to a 3 hp cabinet saw in the next couple of years.
If
I can get something similar to what's on my supersaw, I'll buy it.

And which sliding table do you have, made by Jet? Got a link to it?



They make one for their supersaw (which is what I have). They also have a
sliding table for the powermatic PM66. I've never seen it.

Here's the link for the Jet model with sliding table. The picture shows the
sliding table with cross cut fence in place. The fence is held on with two
large 3/8" threaded handles that screw into pre-drilled holes on the cast
table. It takes about 30 seconds to remove or mount the fence and it always
locks precisely into the same location every time.

http://www.wmhtoolgroup.com/index.cf...tail&iid=12993

Bob