On Wed, 27 Apr 2005 11:45:42 -0600, Scotty wrote:
I am shopping for a table saw, and have narrowed the choices
down to the Unisaw and a couple others. I really like the
sliding tables, and see that Delta has one too.
I would like some comments about the Delta sliding mitre table
on a Unisaw, as to accuracy, smoothness, solidity, etc...
Also, any comments good or bad as to sliding tables in general,
such as why I should avoid them, or why I would love one would
be welcome. Any experience with other makers' tables, such as
Jet and Grizzly?
Thanks so much,
Scotty
===============
Darn I also have very little experience in using a keyboard also...
Last message was sent when all I wanted to do is backspace and fix a
typo....
Oh well... All I was going to ask is what the original poster
intended to use his saw for....production work or hobbyist
use.... I am a hobbyist and 3-4 sleds cover just about any cut I
needed over the years...lot less expensive...
Bob Griffiths
|