Thanks for the informative answer to my question. YOu mentioned putting
down screening but you did not mention a hardcore layer like gravel
before that. Am I right that you just put limestone screening, and how
many inches of it may I ask ?

J

World Traveler wrote:
Pavers and walkways are a good example of the 90 /10 rule. You can
do 90%
of the work in 10% of the time. if 90% is good enough for you, fine,
but it
will still look like a homeowner weekend project rather than a
compliment to
your house.

It depends upon the appearance you want to achieve. Actually, I
think the
large 24" x 24" blocks aren't really intended for a professional
paving
block installation. Lots of folks just space the blocks out like
stepping
stones and the result is just that -- a homeowner's low cost walkway
-- not
that there's anything wrong with that -- . If you're trying to do a
solid
long walkway or a patio you'll have problems keeping the large blocks
level
from block to block. The smaller interlocking pavers are much easier
to
install in that respect.

But before you decide, I suggest you also find a professional
installation
of interlocking pavers (the small, interlocking kind) which will show
you
what is possible. A well-done paving block walk or patio is very
handsome.
An installation of this type should go a long ways in improving the
appearance of your walkway and a visitor's impression of your house.

I've added a paving block patio, walkway and also "blocked" the south
and
east perimeter of the house, adding built in sections for gardens. I
went
the full route, with pavers, a bed of screening, tamping, etc., and
we
wouldn't have been satisfied by just putting down the 24 x 24 blocks
on
unprepared soil.

"m Ransley" wrote in message
...
Do it the easy way if you want I did several times and no problems.
The
24x24 are thick and wont break just make them so they dont rock.
Alot
of DIY info is overkill.