No! Think where the groove is, for one thing. Think about the scale of
the profile on a kitchen cabinet with a rail/stile about 2-1/2" wide, vs
the width of rails on a door.

Dave

habbi wrote:

A 1.5" thick door is basically 2 3/4" cupboard doors back to back. Couldn't
you just do one side of all the styles and rails and then flip them over and
do the other? And the same for the raised panels?

"David" wrote in message
...

Is your question, "can I use router bits instead of shaper bits to make
1 1/2" panel doors"? I've not seen any router bits for rails and stiles
that cover 1.5", but maybe they are out there somewhere. Sounds like a
shaper kinda task.

Dave

habbi wrote:


Can a bit set for making cabinet doors be used to make full size 1.5"

thick

80" tall) panel doors. What are some tips on making full size doors?

Thanks