writes:

Hi,
I am doing a tune up on an old turntable I have and according to the
service manual I need to make measurements with a VTVM (vacuum-tube
voltmeter). I own a Fluke 111 DVM, is there any reason why this can not
work in place of the VTVM.

No. They didn't have DVMs when that service manual was written!

--- sam | Sci.Electronics.Repair FAQ Mirror: http://repairfaq.ece.drexel.edu/
Repair | Main Table of Contents: http://repairfaq.ece.drexel.edu/REPAIR/
+Lasers | Sam's Laser FAQ: http://repairfaq.ece.drexel.edu/sam/lasersam.htm
| Mirror Sites: http://repairfaq.ece.drexel.edu/REPAIR/F_mirror.html

Note: These links are hopefully temporary until we can sort out the excessive
traffic on Repairfaq.org.

Important: Anything sent to the email address in the message header above is
ignored unless my full name is included in the subject line. Or, you can
contact me via the Feedback Form in the FAQs.