On 16 Apr 2004 02:49:18 -0700, (Dave Phillips)
wrote:

FOlks

Zanussi washing machine, model FL1025, ca. 1990 vintage

Has recently developed an intermittent fault where it will not go into
spin and drain at the end of a wash cycle. Program dial runs to its'
end point, but spin does not kick in. Machine just stops instead. Can
usually be rectified by selecting spin cycle manually, but sometimes
takes 5 or 6 goes to actually acheive the spinnage, and this is
getting boring.

Worth repairing? Something i cold do myself (I'm a techie) or a
call-out job? If so, do Zanussi offer an at-home repair service these
days, and is it any good?

wonderingly
Dave P
London E.

I had a similar issue - not with a Zanussi, the end of the outlet pipe
was in the water in the drain pipe. I lifted it up a bit, so the is an
air gap and it works *MUCH* better.

Rick