Crag wrote:

I bought a venting kit similar to this (http://www.plumbworld.co.uk/84-486)
from Focus allthough I also have three plastic pins/clips with it.
My very basic question is what the hell do I do with it? Where does the
self adhesive ring go? If it goes on the wall does it go on before or after
the plastic sleeve. What do I do with the clips?

Probably thought they they didn't need to provide intructions with it as it
is so simple, but I'm proving them wrong.

Well, a good starting point would be to ask you what you bought
it with the intention of doing?

Are you using it to connect the pipe to the dryer, a wall vent or
what? Do you just have a hole in the wall?

I believe the pegs can be pushed through the thin plastic of the
pipe into the holes in the fitting to keep it in place.

I'm guessing that the adhesive ring could hold the whole assembly
against an outlet on which it was not a snug fit. To do this you
might assembly the pipe to the fitting, then slide the ring along
to stick everything to the dryer or wall.

Regards
Chris
--
Chris J Dixon Nottingham UK


Have dancing shoes, will ceilidh.