Hi,
I want to mount a VFD over the headstock of my lathe,
on the wall. This VFD comes with 1/2 knockouts so I
can cable directly to the VFD. My question is this
a safe place to mount the VFD as far as getting
splattered by any oil from the lathe?
VFD is rated @ IP20 (which I believe is about nothing).
Is there any RF issues that I should be concerned
about that makes mounting the VFD in an enclosure
desirable? I would assume the motor radiates more
noise than VFD would.
If I can mount it there without an enclosure,
then I don't need to remote the display.
Picture in the dropbox:
http://www.metalworking.com/dropbox/VFD_placement.jpg
Thanks,
Wayne D.